VIS-FS100-A feedback suppressor uses a powerful signal processor and a fully automatic adaptive algorithm, which is easy to use. In addition to supporting 4-line / microphone input, it is also equipped with an AUDIOLINK digital audio cascade interface and supports 5 channel automatic
mixer.
The adaptive filter can switch between "Fast" mode and "Precise" mode. Fast mode is suitable for situations where the microphone position changes frequently. Adaptive filters converge at a slower rate, suppressing more reverberation components. Depending on the acoustic environment
and the selected operating mode, an additional gain of up to 12DB can be obtained before acoustic feedback occurs.
The feedback suppressor also has a built-in automatic mixer to achieve four microphone inputs. In many cases, such as on a podium, pulpit, or conference table, the use of the above two microphones can better capture the voice of a moving speaker, which often increases the risk of
acoustic feedback. In view of this problem, the automatic mixer in the feedback suppressor will automatically reduce the gain of the microphone with a weak signal input, while increasing the gain of another microphone with a strong signal input. In this way, it can track the speaker on the move, producing the best sound clarity. At the same time, since the total amount of gain remains constant, a maximum volume is maintained without generating acoustic feedback.
When the feedback suppressor is configured with two AUDIOLINK cascade interfaces, it is connected to the CLEACON series conference controller through the AUDIOLINK interface, and the conference controller outputs audio to the feedback suppressor for mixing output, and can be
cascaded to the next feedback suppressor or Other devices with AUDIOLINK interface.
Even if the feedback suppressor is switched to the "bypass" mode, the automatic mixer functionstill works
Control & Indicators
-Switch
-Bypass button with yellow LED
-Activate ACTIVE button with yellow LED
- Calibration button. Start quick calibration cycle
--4-channel microphone / line input status indicator
- Overload (at 0DBFS), red
- Enable AutoMix, yellow
- Calibration, yellow
Electrical characteristics
Power supply voltage .......230VAC / 115VAC, ± 10%, 50 / 60HZ
15W
Maximum starting power .......1.5A (230VAC) / 3A (115VAC)
Sampling rate....... 32KHZ
Frequency response.......125HZ-15KHZ
<1% at 1KHZ distortion
Gain .......0dB line in, 12dB / 0dB / -12dB (Low / Med / High) microphone input
Gain adjustment range....... Mute ~ 20dB
S / N ratio.......> 90DB
Signal delay .......<11 ms
Decoupler frequency variation....... up to 5HZ shielding noise
Line / microphone input
Maximum input level....... 6dBv
Output resistance....... <100 ohm
CMRR.......> 25DB (50HZ-20KHZ)
24V phantom power (microphone only, switchable)
10dBv maximum output level
conventional
Relative temperature ∠95%
Weight 3 kg
Operating temperature range from 10 ° C to 55 ° C
Storage temperature range 40 ° C to 70 ° C
Relative humidity <95%
Audited Supplier 
){kind=link}